When maximum productivity, durability, and cut quality are your priorities, the new Exmark Lazer Z Diesel zero-turn mowers are the right choice. When equipped with the new industry-leading 144-inch UltraCut™ Flex Wing cutting deck, the Lazer Z Diesel can mow 11.5 acres per hour, making it the most productive mower Exmark has built. Powered by a cutting-edge Yanmar diesel engine, large drive tires allow you to reach ground speeds up to 12.5 MPH with the 96" deck. The Lazer Z Diesel is also available with 60 and 72-inch UltraCut™ cutting decks. Delivering a high-quality cut, the flex wings on the 96-inch and 144-inch decks pivot 20-degrees up and 15-degrees down on sloping terrain.
SeatDeluxe, two-tone, bolstered suspension seat with Elastomeric Vibration Control material. Mounted on innovative Seat Isolation System that provides operator isolation in all three planes of motion as well as fore-aft slide and seat flip-up.
Electrical12-volt battery with 55-amp alternator.
Onboard IntelligenceRED Technology
Standard Features12-volt plug-in, engine hour meter and cup holder
Fuel SystemCommon Rail Diesel
Engine Speed3,000 RPM
Air FilterHeavy-duty canister air filtration system with electronic vacuum sensor
Fuel Capacity12-gallon (45.4-L), side fuel tanks
Fuel IndicatorYes - mechanical float type
Drive DescriptionKanzaki KPS-18T Transmission, 16-quart oil capacity, spin-on filter. 18 cc shoe type pumps and 17.84 cubic inch Hydro-Gear HGM-18 motors, hydraulic oil cooler.
Safety PackageOperator Presence Controls (OPC) and drive system interlock, with safety interlock system indicators.
ROPS2-post foldable ROPS standard with seat belt and latch.
PTO EngagementIntegrated wet clutch system in transmission, connected to right angle gearbox on deck via drive shaft
Drive Wheel ReleaseAllows unit movement without engine running.
Width / Cutting Deck96"
Deck StyleFloating Deck
Deck Style DescriptionFull-floating UltraCut Rear Discharge Deck. Rear-discharge standard with finish cut baffles included.
Deck Construction7-gauge high strength alloy top that is formed and continuously seam welded, with 7-gauge high strength alloy side skirt.
Blade Tip SpeedApproximately 18,500 fpm
Cutting Heights1.0" (2.5 cm) to 5.5" (11.8 cm) in 0.25" (0.64 cm) increments.
Blades4 Blades at 24.50" Length
Width101.2 in. (257.0cm), 72.5 in. @ 3 in. HOC when folded
Length97.2 in. (246.9 cm)
Height71.8 in. (182.4 cm)
No Downtime Policy
Has your mower ever broken down in the middle of May when the grass is growing an inch an hour and the repair shops have a two week wait? You never have to go thru that again! Because when you buy a mower at American Pride with a pre-tax value of greater than $4000, we will give you one to use while yours is getting fixed. Just bring us your mower (pick-up available) and if we cannot fix it within an hour – we will load you up with a loaner!